TM 5-2815-241-34&P
CYLINDER BLOCK - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
31. Adapter plate (6)
Torque reaction
bar (8)
Install into place.
32. ST-1081 boring
tool (4)
Drive gear (9), 1/2-
inch drive flex
drive adapter (10)
and 1/2-inch porta-
ble electric drill (11)
Engage 1/2-inch drive flex drive adapter
into 1/2-inch portable electric drill,
fasten in place, and engage onto drive
gear.
WARNING
Safety goggles must be worn to prevent eye injury caused by flying steel chips.
NOTE
Be sure ST-1081 boring tool drive shaft is in maximum up position before turning on
drill.
33.
1/2-inch portable
electric drill (11)
a.
Using 1/2-inch portable electric drill,
apply a slight downward pressure until
maximum depth of bore is complete.
b.
Pull drive shaft of ST-1081 boring tool up
until shaft is in up position.
34. Cylinder block (1)
ST-1081 boring
tool (4)
Remove from cylinder block.
TA 242437
2-157
|
|