TM   5-2815-241-34&P CAM   FOLLOWER   ASSEMBLY   -   CONTINUED ACTION LOCATION ITEM REMARKS 2.  Cam  follower housing  (1) Two  lockscrews  (3) Using  1/4-inch  flat-tip  screwdriver, unscrew and take out. 3. Two  cup  plugs  (4) Using   16-ounce   ball-peen   hammer   and center  punch,  knock  out. Discard. CAUTION When removing cam follower shafts, center drive pin on cam follower shaft and tap lightly.  Striking  housing  or  cam  followers  will  cause  damage. NOTE When removing cam follower shaft, remove and set aside cam followers as they become free from cam follower shaft. 4. Cam  follower shafts  (5) Using  arbor  press  and  ST-1053  plug  driving mandrel,  press  out  of  cam  follower housing  (1). NOTE Steps  5  and  6  are  typical  for  all  cam  follower  levers. 2-255