TM   5-2815-241-34&P CAM   FOLLOWER   ASSEMBLY   -   CONTINUED ACTION LOCATION ITEM REMARKS DISASSEMBLY  -  CONTINUED 5.  Cam  follower lever (1) Roll  pin  (2) Using   16-ounce   ball-peen   hammer   and 3/32-inch   drive-pin   punch,   drive   out. Discard  roll  pin. 6. Cam  follower  roller pin (3) a. Using  arbor  press  and  ST-970  plug  driv- ing mandrel, press out of cam follower lever (1). b. Remove  cam  follower  roller  (4). CLEANING NOTE For  general  cleaning  procedures,  see  General  Maintenance  Instructions,  page  2-3. INSPECTION WARNING Drycleaning solvent P-D-680 is toxic and flammable. Wear safety goggles and gloves and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes and do not breathe vapors. Do not use near open flame or excessive heat. Flashpoint for type #1 drycleaning solvent is 100°F (38°C) and for type #2 is 138°F (59°C). If you become dizzy while using solvent, get fresh air immediately, and get medical aid. If contact with eyes is made, wash your eyes with water, and get medical aid immediately. Failure to observe  these  precautions  could  cause  serious  injury  or  death  to  personnel. Particles blown by compressed air are hazardous. Make certain the air stream is directed away from user and other personnel in the area. Compressed air used for cleaning  purposes  shall  not  exceed  30  psi  (207  kPa).  User  must  wear  safety  goggles  or face shield to prevent injury. 7. Cam  follower lever (1) Wipe clean with rag and inspect for breaks or clogged oil passages. Check for cracks and imperfections  by  visual  and  magnetic inspection. If  broken  or  cracked,  replace.  If oil  passages  are  clogged,  clean  with drycleaning  solvent  and  use  com- pressed  air  to  thoroughly  clean  oil passages. 2-256