TM   5-2815-241-34&P CAM   FOLLOWER   ASSEMBLY   -   CONTINUED ACTION LOCATION ITEM REMARKS 8. Cam  follower roller  pin  (3) a. Inspect for breaks, cracks, or out-of- round   condition. If  broken,  cracked,  or  out-of-round, replace. b. Using  0-  to  1-inch  micrometer,  mea- sure  outside  diameter. If  outside  diameter  is  less  than 0.497  inch  (12.82  mm),  replace. New  roller  pins  should  measure 0.4995  to  0.500  inch  (12.89  to 12.70 mm). 9. Injector cam follower  roller  (4) a. Inspect for breaks, cracks, or out-of- round   condition. If  broken,  cracked,  or  out-of-round, replace. b. Using dial bore gage, measure inside diameter  of  injector  cam  follower roller at several points for wear. If  lager  than  0.505  inch  (12.83 mm),  replace. New  roller  inside  diameter  should  be 0.503  to  0.504  inch  (12.78  to 12.80   mm). c. Using  a  1-  to  2-inch  micrometer,  mea- sure  outside  diameter  of  injector  cam follower  roller  at  several  points  for wear. If  smaller  than  1.2485  inches  (31.71 mm),  replace. New  roller  outside  diameter  should  be 1.2490  to  1.251  inches  (31.72  to 31.77 mm). 2-257