TM 5-2815-241-34&P
CAM FOLLOWER ASSEMBLY - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSPECTION - CONTINUED
16.
Cam follower
housing (1)
a.
Inspect for cracks, breaks, and
damaged mating surfaces.
If cracked, broken, or mating sur-
faces damaged, replace.
b.
Inspect edges of cup plug holes (2)
for sharp edges, nicks, or burrs.
Using emery cloth, remove sharp
edges, nicks, burrs and chamfer
edge of holes to aid in installation of
cup plug.
ASSEMBLY
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear safety goggles and gloves
and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes, and
do not breathe vapors. Do not use near open flame or excessive heat. Flashpoint for
type #1 drycleaning solvent is 100°F (38°C) and for type #2 is 138°F (59°C). If you
become dizzy while using solvent, get fresh air immediately, and get medical aid. If
contact with eyes is made, wash your eyes with water, and get medical aid immediately.
Failure to observe these precautions could cause serious injury or death to personnel.
CAUTION
Make sure that all parts are free from dust and dirt.
2-260
|
|