TM 5-2815-241-34&P
FUEL PUMP - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
DISASSEMBLY - CONTINUED
3. Fuel pump
assembly (1)
Four screws (2),
four lockwashers
(3), four flat
washers (4), two
preformed packings
(5), and pulsation
damper (6)
4.
5.
Four screws (7),
four lockwashers (8),
gear pump (9), and
gasket (10)
Shutdown valve (11),
two screws (12), two
lockwashers (13), and
gasket (14)
Lock wire (15), fuel
pump regulator seal
(16), four screws
(17), four lockwashers
(18), four flat washers
(19), governor
spring pack cover (20),
gasket (21), and
bracket (22)
a.
b.
c.
a.
b.
c.
a.
b.
a.
b.
c.
d.
e.
Using 3/16-inch hex key, unscrew and
remove four screws and four lock-
washers.
Discard lockwashers.
Using plastic-faced hammer, tap shoul-
ders of pulsation damper to loosen.
Take off pulsation damper and packing.
Discard packing.
Using 3/16-inch hex key, unscrew and
remove four screws and four lock-
washers.
Discard lockwashers.
Using plastic-faced hammer, tap shoul-
ders of gear pump to loosen.
Take off gear pump and gasket.
Discard gasket.
Using 3/16-inch hex key, unscrew and
remove two screws and two lock-
washers.
Discard lockwashers.
Take off shutdown valve and gasket.
Discard gasket.
Using 8-inch diagonal-cutting pliers,
cut lock wire.
Take off fuel pump regulator seal and
lock wire.
Discard lock wire.
Using 7/16-inch box-end wrench, un-
screw and take out four screws, four
lockwashers, four flat washers, and
bracket.
Discard lockwashers.
Using plastic-faced hammer, tap shoul-
ders of governor spring pack cover to
loosen.
Take off governor spring pack cover
and gasket.
Discard gasket.
2-292
|
|