TM   5-2815-241-34&P FUEL  PUMP  -  CONTINUED LOCATION ACTION ITEM REMARKS 7. Front  cover  (23), screw  (24),  six screws  (27),  seven lockwashers   (25), seven   flat   washers (26),  and  gasket  (28) 8. 9. Throttle  lever  (29), throttle  lever  screw (30),  flat  washer  (31), two   lockwashers (32), and nut (33) Snapring  (34), throttle  shaft  cover (35),  snapring  (36), and  throttle  shaft assembly  (37) a. b. Using  5/32-inch  hex  key,  unscrew  and remove  screw  (24),  lockwasher,  and flat  washer. Using   7/16-inch   box-end   wrench,   un- screw  and  remove  six  screws  (27), lockwashers,  and  flat  washers. c. d. Discard   lockwashers. Using plastic-faced hammer, tap cover and seal to loosen. Take  off  cover  and  seal  and  gasket. Discard   gasket. a. Using   two   7/16-inch   open-end wrenches,  loosen,  unscrew,  and  take off nut. b. Take  off  lockwashers  and  flat  washer. Discard   lockwashers. Take out throttle lever screw. Remove   throttle   lever. c. d. a. b. c. d. Using 6-inch slip-joint pliers, take out snapring   (34). Remove throttle shaft cover. Using  snapring  pliers,  take  out snapring  (36). Pull  out  throttle  shaft  assembly. Handle  throttle  shaft  carefully. TA  242533 2-293