TM 5-2815-241-34&P
FUEL PUMP - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
THROTTLE SHAFT REPAIR
129. Throttle shaft
Preformed packing
assembly (13)
(14) and ball (15)
a.
Using center punch, 1/4-inch drill bit,
and 3/8-inch electric drill, drill out
ball.
b. Take off packing.
Discard packing and ball.
130.
Fuel adjusting
screw (16)
Using 1/4-inch flat-tip screwdriver, un-
screw and take out.
131. Fuel adjusting
screw (16)
Preformed
packing (17)
Take off.
Discard.
NOTE
Throttle shafts vary with applications. Replace with same size and type if needed.
132.
133. Throttle shaft
assembly (13)
Throttle shaft
assembly (13) and
fuel adjusting
screw (16)
Inspect for wear or damage.
Replace parts as necessary.
Fuel adjusting screw
(16), new preformed
packing (17) and
new preformed
packing (14)
a.
Lubricate with clean fuel oil and Install
packing (17) on fuel adjusting screw.
b.
Screw in fuel adjusting screw about six
turns.
Do not restrict throttle shaft fuel port.
c.
Lubricate with clean fuel oil and install
packing (14) on throttle shaft.
T A 2 4 2 5 5 6
2-329
|
|