TM 5-2815-241-34&P
FUEL PUMP - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
FUEL PUMP ASSEMBLY
134. Fuel pump
housing (1)
135.
136.
137.
138.
139.
Filter screen (2),
spring (3), cap seal
(4) and filter
screen cover (5)
Governor barrel
a.
assembly cover (6)
b.
New cover gasket
(7), governor barrel
assembly cover (6),
bracket (8), four
screws (9), four
flat washers (10),
and four new lock-
washers (11)
Throttle shaft as-
sembly (12), throttle
shaft cover (13), re-
taining ring (14),
and preformed
packing (15)
Throttle lever (16),
throttle lever screw
(17), two new lock-
washers (18), flat
washer (19), and
nut (20)
Governor plunger
Lubricate with lubricating oil and install in
assembly (21)
spring pack housing.
a.
b.
C.
a.
b.
C.
a.
b.
C.
a.
b.
Install filter screen and spring.
Install cap seal on filter screen cover.
Screw in filter screen cover and, using
3/8-inch flat-tip screwdriver, tighten.
Remove all traces of old gasket material.
Inspect for cracks or damage.
Discard If cracked or damaged.
Install new cover gasket, governor barrel
assembly cover and bracket.
Install screws, lockwashers, and flat
washers.
Using 3/8-inch drive 7/16-inch socket
and 0 to 150 In. lb (0 to 16.9 Nm)
torque wrench, tighten to 108 to 132 in.
lb (1.02 to 1.24 Nm).
Install preformed packing and insert
throttle shaft assembly into fuel pump
housing (1) with fuel port facing down
and throttle stop slanted down.
Install throttle shaft cover.
Using 6-inch slip-joint pliers, install
retaining ring.
Install throttle lever on throttle shaft
assembly (11) making sure serrations
are alined and idle position of throttle
lever is near vertical.
Assemble throttle lever screw, flat
washer, lockwashers to throttle lever
and, using two 7/16-inch open-end
wrenches, screw on and tighten nut.
2-330
|
|