TM  5-2815-241-34&P FUEL PUMP CALIBRATION - CONTINUED ACTION LOCATION ITEM REMARKS CLEANING NOTE For  general  cleaning  procedures,  see  General  Maintenance  Instructions,  page  2-3. 1. Fuel  pump  (1) Clean  exterior  surface  thoroughly. MOUNTING  PUMP  TO  TEST  STAND 2.  Test  stand  (2) Drive  coupling  (3) and  test  stand adapter  plate  (4) Install  proper  drive  coupling  and  adapter plate to test stand as required. 3. Fuel  pump  (1),  four screws  (5)  and  four flat  washers  (6) Position fuel pump to adapter plate (4) leaving  1/16  inch  (1.5875  mm)  between fuel pump drive coupling and test stand drive coupling (3), and secure with four screws and four flat washers. 4. Pump  inlet  adapter assembly  (7) Install in pump inlet port (8). 5. 1/2-inch  (12.7  mm) flexible  hose  (9) Connect  from  stand  suction  control  valve (10) to adapter elbow on pump inlet adapter assembly  (7). T A    2 4 2 5 6 0 2-334