TM   5-2815-241-34&P TURBOCHARGER This  task  covers: a.  Disassembly  (page  2-385). b.  Cleaning  (page  2-388) c.  Inspection  (page  2-389) d.  Assembly  (page  2-393) e. Final   Inspection   (page   2-397) INITIAL   SETUP Tools Brush,  soft-bristle Cleaner, parts (with fluid) Extension,   6-inch,   1/2-inch   drive Gage,  bore Gage,  thickness Hammer,   ball-peen,   16-ounce Hammer,  plastic-faced Handle,   hinged,   1/2-inch   drive Handle,   ratchet,   1/2-inch   drive Indicator,  dial Mandrel Micrometer  0-  to  l-inch Micrometer,  1-  to  2-inch Micrometer,  3-  to  4-inch Micrometer,  5-  to  6-inch Press,  arbor Puller,   ST-647 Socket,   7/16-inch,   3/8-inch   drive Socket,   7/16-inch,   1/2-inch   drive Socket,   deep,   3/4-inch,   1/2-inch drive Socket,  ST-1095 Straightedge Support,  bearing,  ST-881 Wrench,   box-end,   7/16-inch Wrench,   box-end,   5/8-inch Wrench,   box-end,   3/4-inch Wrench,  box-end,  1  3/8-inch Wrench,  torque,  0  to  150  in.  lb  (0  to 16.9  N•m),  3/8-inch  drive Wrench,  torque,  0  to  150  ft  lb  (0  to 210  N•m),  1/2-inch  drive Materials/Parts Cloth,  emery  (item  1,  appendix  B) Compound, antiseize (item 2, appendix B) Dye,  leak-detection  (item  7,  appendix  B) Insert,  bearing Lockwasher,  diffuser  plate  (eight  required) Nut,  self-locking,  retaining  strap  (two required) Oil, lubricating (item 12, appendix B) Packing,  preformed,  bearing  housing Packing,  bearing  housing Ring,  oil  control Ring, seal, diffuser plate Ring,   sealing   (two   required) Screw,  retaining  strap  (two  required) Tape,  masking  (item  19,  appendix  B) Washer,  flat,  retaining  strap  (four  required) Equipment   Condition Turbocharger  removed  (page  2-12). 2-384 Change  1