TM   5-2815-241-34&P TURBOCHARGER  -  CONTINUED ACTION LOCATION ITEM REMARKS DISASSEMBLY NOTE Exterior of turbocharger should be cleaned before disassembly. Mark compressor cas- ing, diffuser plate, turbine casing, bearing housing, and clamps to make certain that parts are assembled in the same position. 1.   Turbocharger   (1) Tape  (2) Remove. Discard. 2. Bearing housing (3) Oil line inlet fitting   (4) Using   5/8-inch   box-end   wrench,   unscrew and take off. 3. Oil line outlet fitting   (5) Using   1   3/8-inch   box-end   wrench,   unscrew and take off. 4. Rotor shaft (6) Self-locking   nut   (7) and  turbine  wheel shaft  (8) a. Using  ST-1095  socket  and  1/2-inch drive  hinged  handle,  hold  turbine  wheel from  turning. b. Using   1/2-inch   drive   3/4-inch   deep socket,   ratchet   handle,   and   6-inch   ex- tension,  unscrew  and  take  off  nut  (7). T A    2 4 2 5 9 6 2-385