TM  5-2815-241-34&P TURBOCHARGER  -  CONTINUED ACTION LOCATION ITEM REMARKS FINAL  INSPECTION  -  CONTINUED 47. Using a dial indicator, measure total end clearance  of  wheels  and  shaft  by  pushing shaft down all the way, and then moving back   again. End  clearance  should  be  0.006  to 0.018 inch (0.15 to 0.46 mm). 48. 49. Spin rotor by hand to make sure no inter- ference   is   present. Cover  all  openings  in  turbocharger  with masking   tape. FOLLOW-ON  MAINTENANCE: Install  turbocharger  on  engine  (page  2-136). TASK  ENDS  HERE ANEROID  CONTROL  VALVE This   task   covers: a.  Disassembly  (page  2-399) c.  Inspection  (page  2-400) b.  Cleaning  (page  2-400) d.  Assembly  (page  2-402) INITIAL  SETUP Tools Materials/Parts Hammer,  plastic-faced Pan,   drain,   2-gallon Pliers,   diagonal-cutting Screwdriver,    flat-tip,    1/4-inch Wrench,   box-end,   7/16-inch Wrench,   box-end,   9/16-inch Wrench,   hex,   3/16-inch Wrench,   open-end,   7/8-inch Cover,   side,   aneroid   control   valve Lockwasher,   bellows Lockwasher,   bellows   cover   (three   required) Packing,  preformed  (two  required) Oil, lubricating (item 12, appendix B) Wire,  locking  (item  21,  appendix  B) Equipment   Condition Aneroid  control  valve  removed  (page  2-25). 2-398