TM  5-2815-241-34&P ANEROID  CONTROL  VALVE  -  CONTINUED ACTION LOCATION ITEM REMARKS DISASSEMBLY  -  CONTINUED 6.  Aneroid  control valve (1) 7. 8. 9. Bellows  washer  (2) bellows  (3),  piston (4),  and  spring  (5) Take  off. Side  control Using 1/4-inch flat-tip screwdriver, pry cover  (6) out. Bellows   actuating shaft  (7),  shaft valve  (8),  and  pre- formed  packing  (9) a. b. Check  valve  (10), gasket  (11),  and air  filter  (12) a. b. C. Discard  side  cover. Lift  up  bellows  actuating  shaft  and  pull out  shaft  valve. Take off packing. Discard. Using   7/8-inch   open-end   wrench,   un- screw  check  valve  and  take  out. Take  off  gasket. Discard  gasket. Using  7/16-inch  box-end  wrench,  un- screw air filter and take out. CLEANING WARNING Drycleaning solvent P-D-680 is toxic and flammable. Wear safety goggles and gloves and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes, and do not breathe vapors. Do not use near open flame or excessive heat. Flashpoint for type  #1  drycleaning  solvent  is  100oF  (38°C)  and  for  type  #2  is  138°F  (59°C).  If  you become dizzy while using solvent, get fresh air immediately, and get medical aid. if contact with eyes is made, wash your eyes with water, and get medical aid immediately. Failure to observe these precautions could cause serious injury or death to personnel. NOTE For  general  cleaning  procedures,  see  General  Maintenance  Instructions,  page  2-3. INSPECTION 10. Bellows  cover  (10) Check for cracks, chips, or warpage. Discard if cracked, chipped, or warped. 2-400