TM   5-2815-241-34&P FINAL   TESTING   AND   ADJUSTMENTS   -   CONTINUED ACTION LOCATION ITEM REMARKS PROCEDURES   BEFORE   STARTING   -   CONTINUED 3. Engine mounted on engine  test  stand Cooling  system 4. Oil  filter  (1) Fill  with  lubricating  oil. 5. Turbocharger   (2) 6. 7. 2-416 Oil  filler  cap  (4) Gearcase   (7) Fill  with  clean  coolant. a. b. C. a. b. C. a. b. C. d. e. f. g. Using   3/4-inch   and   5/8-inch   open-end wrenches,  loosen  and  take  off  oil  inlet line (3). Lubricate bearing with 2 to 3 ounces (60 cc)  of  clean  lubricating  oil. Using  3/4-inch  and  5/8-inch  open-end wrenches,  put  on  and  tighten  oil  inlet line. Take  out  of  rocker  arm  cover  (5). Fill  crankcase  with  lubricating  oil  to  low mark  on  dipstick  (6). Put  in  rocker  arm  cover. Using  1/2-inch  drive  1/2-inch  hex  key socket  and  ratchet  handle,  loosen  and take out priming passage plug (8). Install  priming  pump  from  source  of clean  lubricating  oil  to  plug  boss  in gearcase. Prime  system  until  a  30  psi  (207  kPa) maximum pressure is developed. Crank engine at least 15 seconds with fuel  shutoff  closed,  while  maintaining oil pressure at a minimum of 15 psi (103.5 kPa). Remove   priming   pump. Using  1/2-inch  drive  1/2-inch  hex  key socket and ratchet handle, put in and tighten  priming  passage  plug. Clean area of any lubricating oil spilled while  priming.