TM 5-2815-241-34&P
ROCKER ARM HOUSING REMOVAL
INITIAL SETUP
Tools
Materials/Parts
Handle, ratchet, 3/8-inch drive
Mallet, rubber
Screwdriver, flat-tip, 3/8-inch
Socket, 7/16-inch, 3/8-inch drive
Wrench, box-end, 5/8-inch
Wrench, box-end, 3/4-inch
Tags, marker (item 17, appendix B)
Equipment Condition
Engine compression brake housings removed
(page 2-28).
ACTION
LOCATION
ITEM
REMARKS
NOTE
Before performing following steps, tag rocker arm housings with location on engine.
Steps given are typical for all three rocker arm housings.
1. Intake and exhaust
valve rocker
arms (1)
Locknut (2) and
adjusting screw (3)
2. Fuel injector rocker
Locknut (5) and
arm (4)
adjusting screw (6)
Using 3/4-inch box-end wrench and 3/8-
inch flat-tip screwdriver, loosen locknut and
unscrew adjusting screw until rocker arm
moves freely.
Using 3/8-inch drive 7/16-inch socket,
ratchet handle, and 3/4-inch box-end
wrench, loosen locknut and unscrew adjust-
ing screw until rocker arm moves freely.
NOTE
Rocker arm studs are different lengths. Before performing step 3, tag rocker arm studs.
See illustration for location and lengths.
TA 242353
2-30
|
|