TM    5-2815-241-34&P CYLINDER HEAD FUEL LINE REMOVAL INITIAL  SETUP Tools Tools  -  Continued Handle,   ratchet,   1/2-inch   drive Socket,   9/16-inch,   1/2-inch   drive Wrench,   open-end,   1/2-inch Wrench,   open-end,   9/16-inch Wrench,   open-end,   5/8-inch ACTION LOCATION ITEM REMARKS 1.  Rear cylinder head  (1) Two fuel line nuts (2) and two fittings   (3) a.  Using  1/2-inch  open-end  wrench, loosen  and  disconnect  fuel  line  nuts. b. Using   5/8-inch   open-end   wrench,   un- screw  and  take  out  fittings. Install  fittings  on  fuel  line  nuts  to prevent  loss. 2.  Fuel  shutoff switch  (4) 3. Fuel pump (7) 4.  Left side of cylinder  block Fuel  line  nut  (5) and  fitting  (6) Using  5/8-inch  and  1/2-inch  open-end wrenches,  loosen  and  disconnect. Fuel  line  nut  (8) and  fitting  (9) Using   9/16-inch   open-end   wrench,   loosen and  disconnect  fuel  line  nut. Three  screws  (10), three   lockwashers (11),  three  clamps (12),  and  two  fuel lines  (13) Using  1/2-inch  drive  9/16-inch  socket  and ratchet  handle,  unscrew  and  take  off. Discard    lockwashers. Install  three  screws  in  cylinder  block  to prevent  loss. TASK  ENDS  HERE TA  242352 2-29