TM  5-3895-360-13 CHAPTER  12 ACCESSORY ITEMS MAINTENANCE Paragraph Page Paragraph Title Number Number . — 12-1. General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-1 12-2. Data Plates Replacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-1 12-1.   GENERAL. All maintenance procedures in this chapter are to be per- formed by Unit Maintenance. 12-2. DATA PLATES REPLACEMENT TOOLS: General mechanic’s tool kit . . . . . . . SC 5180-90-N26 NOTE Refer  to  Figure  12-1,  Data   Plate   Replace- ment.   All data plates are replaced the same way. Fuel tank data plate is illustrated. REMOVAL a. Remove data plate (2) from fuel tank(1). WARNING Dry  cleaning  solvent,  P-D-680,  is  toxic  and flammable.  Always  wear  protective  goggles and gloves, and use only in a well-ventilated area.   Avoid   contact   with   skin,   eyes,   and clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat. The solvent’s flash point is 100°F-138°F (38°C-59⁰C). if you become dizzy while using cleaning solvent, immediately get fresh air and medical help. if solvent contacts eyes, immedi- ately wash your eyes and get medical aid. b. Remove remaining adhesive from fuel tank (1) with dry cleaning solvent (Item 16, Appendix E) and allow area to dry. INSTALLATION a. Apply adhesive (Item 1, Appendix E) to back of data plate (2). b. Install data plate (2) on fuel tank (1). Figure 12-1. Data PIate Replacement. 12-1/(12-2 Blank)