TM   5-3895-360-13 7-8.  CARBURETOR  REPAIR  (Con’t). NOTE a. Clean carburetor with dry cleaning solvent (Item 16, Appendix E) and dry with compressed air. Refer to Figure 7-14, Body Channel Plug and Welch Plug Replacement, for steps p and q. b. Inspect carburetor for damage. Replace carburetor if damaged. p. Remove body channel plug (44) from carburetor (1). Discard body channel plug. WARNING q. Remove welch plug (45) from carburetor(1). Discard welch plug. Dry  cleaning  solvent,  P-D-680,  is  toxic  and flammable.  Always  wear  protective  goggles and gloves, and use only in a well-ventilated area.   Avoid   contact   with   skin,   eyes,   and clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat. The solvent’s   flash   point is   100°F-138°F (38°C-59°C). If you become dizzy while using cleaning solvent, immediately get fresh air and medical help. if solvent contacts eyes, lmmedi- ately wash your eyes and get medical aid. . c.  Clean  all  parts  with  dry  cleaning  solvent  (Item  16, Appendix  E)  and  dry  with  clean  rags  (item  15, Figure 7-14. Body Channel Plug and Appendix E). Welch  Plug  Replacement. d. Inspect parts for damage. Replace damaged parts. CLEANING AND INSPECTION ASSEMBLY NOTE WARNING Dry  cleaning  solvent,  P-D-680,  Is  toxic  and flammable.  Always  wear  protective  goggles and gloves, and use only in a well-ventilated area.  Avoid  contact  with  skin,  eyes,  and clothes,  and  DO  NOT  breathe  vapors.  DO NOT use near open flame or excessive heat. The  solvent’s  flash  point  is  100^O”F-138°F (38°C-59°C). if you become dizzy while us- ing cleaning solvent, immediately get fresh air  and  medical  help.  if  solvent  contacts eyes, immediately wash your eyes and get medical aid.   Compressed air used for cleaning or drying purposes, or for clearing restrictions, should never exceed 30 psi (207 kPa). Wear protec- tive  clothing  (goggles/shieid,  gloves,  etc.) and use caution to avoid Injury to personnel. Refer to Figure 7-14, Body Channel Plug and Welch Plug Replacement,  for steps a and b. a. Install new welch plug (45) in carburetor (1). b. Install new body channel plug (44) in carburetor (1). NOTE Refer to Figure 7-13,  Throttle  Shutfer,  Throttle Lever Choke Valve, and Choke Lever Replace- ment, for steps c through h. c. Install spring (42) and choke ball (41) in carburetor (1). d. Install two sleeve bushings (38) on carburetor (1). 7-14