TM 5-3895-360-13
10-2. TRANSMISSION ASSEMBLY MAINTENANCE (Cont).
f.
g.
h.
l.
j.
k.
1.
Install pinion gear (22) on shaft (21) with retaining
ring (23).
Position shaft (21) in gearcase (14).
Install woodruff key (19) in shaft (21).
Install spur gear (18) on shaft (21) with retaining ring
(17).
Install bushing (26) in crankshaft (27).
Install bearing (25) and crankshaft (27) in gearcase
(14).
NOTE
Refer to Figure 10-4, Transmlsslon Gearcase
Cover Bearings Replacement, for step I.
Install three bearings (16) In gearcase cover (12).
NOTE
Refer to Figure 10-3, Transmlsslon Gearcase Cover
Replacement, for step m.
m. Install new gasket (13) and gearcase cover (12) on
gearcase(14) with 14 screws(15) and two pins (11).
INSTALLATION
NOTE
. Refer to Figure 10-2, Transmission Replace-
ment (VR11), for step a.
Perform step a forVR11 only.
a. Install six resilient mounts (10) and transmission as-
sembly (9) on handle (8) with six nuts (7).
NOTE
Refer to Figure 10-1, Transmlsslon Replace-
ment (VR11C), for step b.
Perform step b for VR11 C only.
b. Install six resilient mounts (6) and transmission as-
sembly (5) on handle (4) with six washers (3), new
Iockwashers (2), and screws (1).
c. Install engine assembly (see paragraph 6-2).
d. Install lower unit (see paragraph 13-3 or 13-4).
10-3. TRANSMISSION CLUTCH REPLACE-
MENT
TOOLS:
General mechanics tool kit . . . . . . . SC 4910-95-N26
Retaining ring pliers . . . . . . . . . . . . . SC 4910-95-A31
Mechanical puller kit:
Gear and bearing ., . . . . . . . . . . . SC 4910-95-A31
REMOVAL
a.
b.
c.
Remove handle (see paragraph 11-2 or 11-3).
Remove engine assembly (see paragraph 6-2).
NOTE
Refer to Figure 10-7, Transmission Gearcase
Cover Replacement, for step c.
Remove 14 screws (5), two pins (1), gearcase cover
(2), and gasket (3) from gearcase (4). Discard gas-
ket.
10-7
|
|