Explanation of Columns in Tools and Test Equipment Requirements, Section III.

Custom Search

Back
Appendix B. MAINTENANCE ALLOCATION CHART

Up
TM-55-4920-436-13-P Engine Shop P/N SC-4920-97-CL-A60 Manual

Next
SECTION II. MAINTENANCE ALLOCATION CHART FOR ENGINE SHOP

TM 55-4920-436-13&P

d. Column 4, Maintenance Category. Column 4 specifies, by the listing of a work time figure (hours) in the

appropriate subcolumn(s), the category of maintenance authorized to perform the function listed in Column 3. This figure

represents the active time required to perform that maintenance function at the indicated category of maintenance. The

work time figure represents the average time required to restore an item (assembly, subassembly, component, or end

item) to a serviceable condition under typical field operating conditions.

e. Column 5, Tools and Equipment. Column 5 specifies, by code, those common tool sets (not individual tools) and

special tools, TMDE, and support equipment required to perform the designated function.

f. Column 6, Remarks. This column, when applicable, contains a letter code, in alphabetic order, which is keyed to

the remarks contained in Section IV.

B-4. Explanation of Columns in Tools and Test Equipment Requirements, Section III.

a. Column 1, Reference Code. The tool and test equipment reference code correlates with a code used in the

MAC, Section II, Column 5.

b. Column 2, Maintenance Category. The lowest category of maintenance authorized to use the tool.

c. Column 3, Nomenclature. Name or identification of the tool.

d. Column 4, National Stock Number. The National Stock Number of the tool.

B-5. Explanation of Columns in Remarks, Section IV.

a. Column 1, Reference Code. The code recorded in Column 6, Section II.

b. Column 2, Remarks. This column lists information pertinent to the maintenance function being performed as

indicated in the MAC, Section II.

B-2