C H A P 5, SEC II
D I S A S S E M B L Y
P A R 75, S T E P S 2 3 - 2 6
Figure 89 (Step 25)
F i g u r e 8 7 ( S t e p 2 3 )
Using lifting sling (A), remove converter hous-
ing assembly (B) and gasket (C) from trans-
m i s s i o n h o u s i n g ( D ) . U s e j a c k s c r e w s ( E ) , to
s e p a r a t e h o u s i n g s R e m o v e t r a n s m i s s i o n
left-output shaft (F). Remove O-ring seal (G)
from housing (B).
R e m o v e s c r e e n c o v e r ( A ) , g a s k e t ( B ) a nd
o i l s c r e e n ( C ) .
Figure 88 (Step 24)
Figure 90 (Step 26)
Using a 5/8-inch wrench, remove the remain-
i n g c o n v e r t e r - t o - m a i n t r a n s m i s s i o n h o u s i ng
bolts (A) and lock washers (B).
9
0
Using a 1-inch wrench, and while applying the
left brake, loosen bolt (A).
|
|
