TM 9-2520-272-34&P 4-13. INSTALL INPUT HOUSING ASSEMBLY (SHEET 1 OF 3) Task Title Page 1 Install Input Housing Assembly 4-46 TASK 1.  INSTALL INPUT HOUSING ASSEMBLY COMMON TOOLS: Adapter, socket wrench, 1/2 to 3/8 inch square drive Extension, socket wrench, 3/8 inch square drive, 10 inch Handle, socket wrench, 3/8 inch square drive Press, arbor, hand operated Punch, aligning, tapered, 1/4 inch diameter point Screwdriver, flat tip, 1/4 inch wide tip Socket, socket wrench, 3/8 inch square drive, 9/16 inch Universal Joint, socket wrench, 3/8 inch square drive Wrench, torque, 0-175 lb-ft REPAIR PARTS: Seal, V-ring (steer shaft) (73342) 23018034 used with Housing PN 23018026 Seal, V-ring (steer shaft) (73342) 23048292 used with Housing PN 23048310 SUPPLIES: Adhesive-sealant, RTV, Type I (Item 1A, Appendix C) Petrolatum (Item 14, Appendix C) NOTE Transmission  on  maintenance  stand, input side turned up. 1 Install   bevel   gear    gasket    (1)    on    bevel    gear assembly (2). 2 Install    input    housing    gasket    (3)    on    center housing (4). CAUTION RTV   adhesive-sealant   begins   to   set up    very    quickly.    Therefore,    it    is necessary for the input housing to be installed  onto  the  transmission  main housing within 30 minutes of applying RTV to steer shaft seal. 3 Install new seal (5) on steer shaft (6) with thin lip of seal out. 4 Apply  an   0.25   inch   (6.3   mm)   maximum   width bead  RTV  adhesive-sealant  around  the  OD  of seal (5). Go to Sheet 2 4-46  Change 2 Para.  4-13, Task 1