TM 9-2520-272-34&P
4-14.
INSTALL CONVERTER ELEMENT COMPONENTS
(SHEET 2 OF 7)
1 Using screwdriver, install two 5/16-24 x 3 inch guide
pins (1) 180 degrees apart in shoulder of input pump
drive gear (2).
2 Install converter pump gasket (3) over guide pins (1)
and onto shoulder of input pump drive gear (2).
3 Install rotary pump (4) over guide pins (1).
NOTE
Be sure pump (4) is down far enough to allow
inner lips on retainers (5) to seat in groove
on bearing (6).
4 Using plastic faced hammer, tap pump (4)
pump on gasket (3).
5 Using screwdriver, remove two guide pins
6 Put two converter bearing retainer plates
eight bolt holes in converter pump (4).
NOTE
to seat
(1).
(5) over
Each locking plate goes over two bolt holes
on retainers.
7 Place four new locking strips (7) on retainers, bent
tabs up.
8 Using 1/2 inch socket, install eight cap screws (8) in
locking strips (7) and retainers (5).
9 Use pry bar to prevent rotation of pump (4). Using
torque wrench, tighten eight cap screws (8) to 19-23
Ib-ft (25-31 N•m). Remove pry bar.
Go to Sheet 3
4-50
Para. 4-14, Task 1
|
|
