TM 9-2520-272-34&P 4-15.      INSTALL LEFT END COVER ASSEMBLY (SHEET 9 OF 11) TASK 4   INSTALL OIL LEVEL TUBE ASSEMBLY NOTE: This  task  is   for   the   X200-4A   Transmission only.  Oil fill  tube  must  be  installed  after  the Left Hand End Cover Assembly is installed. COMMON TOOLS: Socket, socket wrench, 3/8 inch square drive, 1/4 inch Extension, 3/8 inch square drive Torque Wrench 3/8 inch square drive Crowfoot, 1-1/4 inch Wrench, 1-1/16 inch Wrench, 1-1/4 inch Socket, socket wrench, 3/8 inch square drive, 9/16 inch Handle, socket wrench, 3/8 inch square drive Wrench, 5/16 inch REPAIR PARTS: Packing, O-ring (1 required) (73342) (29510253) Gasket (1 required) (73342) (29510236) 1    Install new gasket (16) on adapter (14). 2    Using a 1/4 socket, socket (Allen) extension and torque  wrench  install  4  bolts  (15)  that  retain  the gasket   (16)   and   adapter   (14)   to   the   LH   End Cover Assembly (8).  Torque 4 bolts to 27 - 32 lb ft (37 - 43 Nm). 3    Install clamp (3) on oil level tube assembly (2) at the mark previously made. NOTE: Part of clamp with bolt holes should be down and out in relation to oil level tube assembly. NOTE: Bolt    and    washer    should    be    installed    in    top position and nut in bottom position, in relation to clamp. 4    Install bracket (7) on clamp  (3)  by  installing  bolt (9), washer (4) and nut (10).  Do not tighten bolt (9) and nut (10). Go to Sheet 2. 4-63.1  Change2 Para.  4-15, Task 4