TM 9-2520-272-34&P
4-16.
INSTALL RIGHT END COVER ASSEMBLY
(SHEET 7 OF 9)
TASK 2. INSTALL RIGHT END COVER ASSEMBLY
COMMON TOOLS:
Extension, socket wrench, 1/2 inch square drive, 10 inch
Hammer, hand, plastic faced
Handle, socket wrench, 1/2 inch square drive
Hoist, 200-pound minimum capacity
Socket, socket wrench, 1/2 inch square drive, 9/16 inch
Socket, socket wrench, 1/2 inch square drive, 1/2 inch
Wrench, torque, 0-175 lb-ft
SPECIAL TOOLS:
Adapter, brake adjust (19207) 8355595
Sling, three-leg (19207) 12268036
SUPPLIES:
Bolt, 3/8-16 x 3-1/2 inches (2 rewired)
Rag, wiping (Item 15, Appendix C)
Washer, flat, 3/8 inch (4 required)
PRELIMINARY PROCEDURE: Loose components installed in right end of transmission.
Refer to this paragraph, TASK 1.
NOTE
Right brake adjusting cover removed.
Brake adjusting cover restricts access
to right end cover bolt when removing/installing end cover.
Only two legs of three-leg sling used in this task.
Go to Sheet 8
4-70
Para. 4-16, Task 2
|
|
