Custom Search
 
  
 
TM  9-2520-272-34&P 4-17. REMOVE   TRANSMISSION   FROM   MAINTENANCE   STAND (SHEET  1  OF  7) Task Title Page 1 I Remove   Transmission   from   Adapter   Plate I 4-73 2 Remove   Adapter   Plate   from   Maintenance   Stand 4-79 TASK   1.   REMOVE   TRANSMISSION   FROM   ADAPTER   PLATE COMMON   TOOLS: Extension,   socket   wrench,   1/2   inch   square   drive,   6   inch Handle,   socket   wrench,   1/2   inch   square   drive Hoist,   1   ton   capacity   (2   required) Socket,   socket   wrench,   1/2   inch   square   drive,   3/4   inch Socket,   socket   wrench   1/2   inch   square   drive,   9/16   inch Wrench,   torque,   0-175   ft-lb SPECIAL   TOOLS: Sling,   three-leg   (19207)   12268036 Sling,   two-leg   (19207)   12268037 SUPPLIES: Bolt,   3/8-16   x   1-3/4   inches   (3   required) Washer,   flat,   3/8   inch   (6   required) PERSONNEL  REQUIRED:  2 One   soldier   operates   hoist   and   other   soldier   unbolts   transmission   from   adapter   plate when   removing   transmission   from   maintenance   stand. One   soldier   operates   each   hoist   when   turning   transmission   from   horizontal   to   vertical position. WARNING Check   slings   and   lifting   devices   for   cuts,   breaks,   or   wear   before   and   during hoisting.   Slings   and   lifting   devices   can   break   and   cause   injury   or   death. Transmission   weighs   about   910   pounds.   To   avoid   injury   or   death,   keep   out from   under   and   clear   of   transmission   at   all   times.   Do   not   let   transmission swing   freely   during   hoisting. Transmission   will   tilt   suddenly   when   weight shifts   from   one   sling   to   the   other. Go  to  Sheet  2 Para.  4-17,  Task  1 4-73


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business