TM 9-2520-272-34&P
4-16.
INSTALL RIGHT END COVER ASSEMBLY
(SHEET 9 OF 9)
WARNING
Do not tighten end cover bolts unless
Right
End
Cover
is
fully
seated.
Damage to Right End Cover could
result.
6 Using hoist control, rotating output flange (7)
using adapter tool on brake shafts (8), moving
cover (6), lower end cover until it is seated near
gasket (1).
7 Using 9/16 inch socket, remove two bolts (4)
washers (3) and sling from end cover (6).
8 Using 9/16 inch socket and two 3/8-16 x 1-1/2
inch bolts (9) and washers (10), install right lifting
bracket (I ) on right end cover assembly (6).
9 Using 9/16 inch socket, install 3/8-16 x 3-1/2
inch bolt (12) and washer (13) in right end cover
(6).
10 Using 9/16 inch socket, install the 26 remaining
3/8-16 x 1-1/4 inch bolts (14) and washers (15)
around perimeter of right end cover (6).
11 Using torque wrench, tighten all bolts (9, 12, 14)
to 27-32 lb-ft (37-43 Nm).
12 Install right brake adjusting cover gasket (16)
and brake adjusting cover (17) on right end
cover (6).
NOTE
X200-4 Oil filler chain cap is bolted
under the top, outside bolt and washer
of 6 bolts and washers which retain the
plate to the end cover.
13 Using 1/2 inch socket, install six bolts (18)and
washers (19) in brake adjusting cover (17).
14 Using torque wrench, tighten six bolts (18) to 13-
15 lb-ft (17-20 N m).
15 X200-4A right adjusting brake cover should have
a pipe plug (20) installed at oil drain line location
(shipping). If plug (20) is missing, using a 9/16
socket and extension, install plug (20). Using a
torque wrench, torque plug (20) to 18 22 lb ft (24
30 Nm).
NOTE
ì
Output
shaft
drag
check
is
performed after transmission has
been
assembled.
Refer
to
paragraph 5-2.
ì Brake adjustment is performed after
transmission has been assembled.
Refer to paragraph 5-3.
End of Task 2
4-72 Change 2
Para. 4-16, Task 2
|
|
