TM   9-2520-272-34&P 4-18. INSTALL   TRANSMISSION   TOP   COMPONENTS (SHEET   12   OF  16) TASK  7.  CONNECT  WIRING  HARNESS  TO  SOLENOIDS  AND  GROUND COMMON   TOOLS: Extension,   socket   wrench,   1/2   inch   square   drive,   6   inch Handle,   socket   wrench,   1/2   inch   square   drive Socket,   socket   wrench,   1/2   inch   square   drive,   1/2   inch Wrench,   torque,   0-175   ft-lb PRELIMINARY   PROCEDURE: • Wiring   harness   is   pulled   through   center   housing   port;   harness   connector   body   is installed.   Refer   to   this   paragraph,   TASK   2. •  Solenoids   A   through   G   are   installed   on   lockup   control   valve   and   main   control   valve assemblies   Refer   to   paragraph   4-31. •  Lockup   control   valve   and   main   control   valve   assemblies   are   installed.   Refer   to   this paragraph,  TASKS  5  and  6. NOTE •l Connectors   on   solenoids   and   connectors   on   wiring   harness   look   the   same except   for   color. Connectors   are   mated   by   pushing   them   together   with connector   loops   over   bayonets   Connectors   are   locked   in   place   when   ends   of loops   are   down   behind   bayonets. • All   solenoids   are   the   same   and   they   are   interchangeable;   for   that   reason, solenoid   connectors   are   not   marked   with   solenoid   identification.   However, each   lead   of   the   wiring   harness   must   go   to   a   specific   solenoid   location.   Letter stamped   on   wiring   harness   connector   indicates   location   of   solenoid   to   be connected. • Locations   of   solenoids   A   through   G   are   provided   by   art   in   this   procedure. Go  to  Sheet  13 Para.   4-18,   Task   7 4-91