TM 9-2520-272-34&P
4-19.
DISASSEMBLE RIGHT
(SHEET 3 OF 16)
END COVER ASSEMBLY
FOLLOW-ON PROCEDURE: Install output flange,
cooler line elbow and connector. Refer to
paragraph 4-21.
End of Task 1
TASK 2. REMOVE BRAKE APPLY REGULATOR VALVE COMPONENTS
COMMON TOOLS:
Extension, socket wrench, 1/2 inch square drive, 10 inch
Handle, socket wrench, 1/2 inch square drive
Socket, socket wrench, 1/2 inch square drive, 1/2 inch
SUPPLIES:
Rag, wiping (Item 15, Appendix C)
Shim Stock, 1/32 inch thick by 1/2 inch wide by 4 inches long (Item 18, Appendix C)
NOTE
Right end cover is turned inside up.
Spring-loaded parts can fly and injure you.
Always follow specified instructions
when removing bolts from covers that are attached to valve assemblies.
Go to Sheet 4
4-98 Change 1
Para. 4-19, Task 2
W A R N I N G
|
|
