TM 9-2520-272-34&P
4-19.
DISASSEMBLE RIGHT END COVER ASSEMBLY
(SHEET 8 OF 16)
6
7
8
9
10
11
12
13
14
15
16
I
Place support assembly (3) on two wooden blocks with
outside of support up.
(Using 7/16 inch socket, unscrew two bolts (9) until bolt
heads are approximately 1/4 inch above surface of
support (3).
Using plastic faced hammer, tap bolt heads (9) down to
touch surface of support (3).
Using 7/16 inch socket, remove two bolts (9) and
washers (10) from support (3).
Turn support (3) over, inside up.
Remove seal retainer (11) and seal ring (12) from
support (3).
Remove seal ring (12) from retainer (11).
NOTE
Stationary cam is not to be removed unless:
• Cam or support is to be replaced.
• Support is to be repaired.
If stationary cam is to be removed, go to
Step 13.
Turn support (3) over, outside up, on wooden blocks.
Using 1/2 inch socket, unscrew three bolts (13) until
bolt heads are approximately 1/4 inch above surface of
support (3).
Using plastic faced hammer, tap bolt heads (13) down
to touch surface of support (3).
Using 1/2 inch socket, remove three bolts (13) and
washers (14) from support (3).
Go to Sheet 9
Para. 4-19, Task 5
4-103
|
|
