TM 9-2520-272-34&P
4-19.
DISASSEMBLE RIGHT END COVER ASSEMBLY
(SHEET 10 OF 16)
1 Remove brake apply cam (1), eight balls (2) and brake adjusting linkage (3) from right end
cover (4). Place balls (2) in a container.
2 Using screwdriver, remove seals (5, 6) from brake cam (1).
3 Using screwdriver, remove preformed packings (7, 8) from face of brake cam (1).
4 Using 7/16 inch socket, remove bolt (9) and two spring
tension clips (10) from brake cam (1).
5 Remove brake adjusting linkage (3) from brake cam (1).
6 Unscrew inner brake adjusting link (11) from outer
brake adjusting link (12).
REPAIR: Refer to paragraph 4-20, TASK 2, for
replacement of pin in inner brake adjusting link (11).
NOTE
Four brake reaction pins (13) can be
removed at this time. Pins (14) cannot be
removed.
7 Remove four brake reaction pins (13).
8 Using finger of one hand, trap retaining ring (15)
against clutch reaction plate (16).
9
Using screwdriver in other hand, pry six retaining rings
(15) away from spring guide pins (17).
Go to Sheet 11
Para. 4-19, Task 6
|
|
