TM 9-2520-272-34&P
4-19.
DISASSEMBLE
RIGHT
END
COVER
ASSEMBLY
(SHEET 16 OF 16)
TASK 9. REMOVE RH OUTPUT SHAFT AND SEAL
COMMON TOOLS:
Hammer, hand, ball peen
Hammer, hand, plastic faced
Pliers, retaining ring, internal
Press, arbor, hand
Punch, drive pin, straight
SUPPLIES:
Blocks, wooden, 2 x 4 inches x 16 inches long (2
required) (Item 2, Appendix C)
Rag, wiping (Item 15, Appendix C)
NOTE
Right end cover turned inside up.
1 Using retaining ring pliers, remove retaining ring
(1) retaining bearing assembly (2) on RH output
shaft (3).
2 Turn right end cover (4) over, outside up, on two
2 x 4 inch wooden blocks.
3 Using plastic faced hammer, drive RH output
shaft (3) bearing (2) and sleeve (5) from output
shaft seal (6).
4 Using ball peen hammer and punch, drive output
shaft seal (6) from right end cover (4).
NOTE
When bearing is removed from output
shaft, sleeve is forced off ahead of
bearing.
5 Inspect
bearing
(2)
and
sleeve
(5)
for
serviceability. If bearing or sleeve requires
replacement, remove bearing (2) and sleeve (5)
from output shaft (3), using arbor press.
FOLLOW-ON PROCEDURE: Install output shaft and
seal. Refer to paragraph 4-21.
End of Task 9
Para. 4-19. Task 9
Change 2 4-111
|
|
