TM 9-2520-272-34&P
4-21.
ASSEMBLE RIGHT END COVER ASSEMBLY
(SHEET 10 OF 22)
Install Stationary Cam and Seal Retainer
1 Turn right brake support assembly (1), inside upward.
2 Install brake stationary cam (2) on two pins (3) in
brake support (1).
3 Using plastic faced hammer, tap stationary cam (2)
onto pins (3) until cam is seated.
4
5
Turn support (1) over, outside up and place on wooden
blocks.
Using 1/2 inch socket, install one 5/16-18 x 2 inch bolt
(4) and washer (5).
6 Using 1/2 inch socket, install two 5/16-18 x 1 inch
bolts (6) and washers (7).
7 Using torque wrench tighten three bolts (4, 6) to
17-20 lb-ft (23-27 N•o).
Go to Sheet 11
Para. 4-21, Task 4
4-135
|
|
