TM 9-2520-272-34&P
4-21.
ASSEMBLE RIGHT END COVER ASSEMBLY
(SHEET 20 OF 22)
When pushing brake apply shaft through seal, be sure that spring in seal stays in
place. Put one hand on outside of end cover, over the brake apply shaft bore,
and run a finger around the spring in the seal to keep the spring in place while
the end of the shaft comes through If the spring does not remain in its proper
position, the seal will leak.
7
8
9
10
11
12
Put one hand on outside of right end cover (4) over left
brake apply shaft (2) bore and run finger around spring
(5) in seal (6) until taped end of brake apply shaft (2)
comes through.
Turning shaft (2) to left or right while inserting it,
carefully push shaft into bore until shaft is seated in
end cover (4).
NOTE
Left brake apply shaft must be held in place
to keep it from falling out of end cover
when end cover is turned over.
Holding shaft (2) in place, turn end cover (4) over,
outside up, then put a wooden block under end cover so
that wooden block retains shaft.
Remove protective tape from end of left brake apply
shaft (2) and right brake apply cam shaft (7).
NOTE
l
Indicator and shaft have one tooth missing
from spline, providing point for alignment.
l
Indicator is installed beveled side of
pointer out.
Install indicators (8) on shafts (2, 7) so that indicators
are beyond inner retaining ring groove (9).
NOTE
Outer retaining rings may or may not be
present. They are furnished to retain
external brake linkage.
Using retaining ring pliers, install four retaining rings
(10).
End of Task 7
Go to Sheet 21
Para. 4-21, Task 7
4-145
C A U T I O N
|
|
