TM 9-2520-272-34&P
4-28.
DISASSEMBLE CENTER HOUSING
(SHEET 10 OF 19)
TASK 5. REMOVE GOVERNOR ASSEMBLY, GOVERNOR BODY ASSEMBLY,
AND GOVERNOR DRIVE GEAR
TOOLS:
Extension, socket wrench, 1/2 inch square drive, 10 inch
Handle, socket wrench, 1/2 inch square drive
Socket, socket wrench, 1/2 inch square drive, 9/16 inch
Socket, socket wrench, 1/2 inch square drive, 1/2 inch
NOTE
Transmission is on maintenance stand, right end up.
1
2
3
Using 1/2 inch socket, remove four bolts (1) and
washers (2) that retain access cover (3) to center
housing.
Remove cover (3) and gasket (4).
Turn governor assembly (5) slightly to the left
(counterclockwise) and pull it from center housing.
4 Using 9/16 inch socket, remove three bolts (6) and
washers (7). Remove governor body assembly (8).
5 Remove governor drive gear (9).
FOLLOW-ON PROCEDURE: Install governor drive
gear, governor body assembly, governor assembly,
and sleeve spacer. Refer to paragraph 4-30.
End of Task 5
Go to Sheet 11
Para. 4-28, Task 5
Change 1
4-181
|
|
