TM 9-2520-272-34&P
4-28.
DISASSEMBLE CENTER HOUSING
(SHEET 11 OF 19)
TASK 6. REMOVE RANGE PACK
TOOLS:
Adapter, socket wrench, 3/8 to 1/2 inch square drive
Extension, socket wrench, 1/2 inch square drive, 10 inch
Extension, socket wrench, 1/2 inch square drive, 6 inch
Hammer, hand, plastic faced
Handle, socket wrench, 1/2 inch square drive
Hoist, 200-pound minimum capacity
Pliers, long round nose
Pliers, retaining ring, internal
Pliers, slip joint, straight nose (2 required)
Pry Bar (2 required)
Screwdriver, flat tip (2 required)
Socket, socket wrench, 1/2 inch square drive, 9/16 inch
Socket Wrench Attachment, socket head screw, 3/8 inch square drive, 5/32 inch hex plug
SPECIAL TOOLS:
Bar and stud assembly (25341) J 24204-2
Compressor, spring (25341) J 24452
Lifter, front support assembly (25341) J 24473
S-hook (19207) 11650102
SUPPLIES:
Bolt, 5/16-18 x 1-1/2 inch
Screw, pitot, 1/4-20 x 3/4 inch (2 required)
NOTE
Transmission is on maintenance stand, left end up.
PRELIMINARY PROCEDURES:
1. Transmission top components are removed. Refer to paragraph 4-5.
2. Left end cover is removed. Refer to paragraph 4-8.
Go to Sheet 12
4-182
Para. 4-28, Task 6
|
|
