TM 9-2520-272-34&P 4-29. REPAIR   CENTER   HOUSING   COMPONENTS (SHEET 6 OF 31) 3 Using   arbor   press,   remove   bearing   (5)   from output shaft (6). NOTE Outer    race    for    bearing    (7)    stays    in retaining   plate   (8)   and   outer   race   for bearing (9) stays in center housing when idler   gear   (10)   is   removed.      Each   of these  separable  bearings  is  a  matched set  consisting  of  an  outer  race  and  an inner     race     and     rollers.          DO     NOT REPLACE these  inner  races  and  rollers unless the outer races  of  the  respective bearings  are  also  being  replaced.  Refer to  this  paragraph,  TASK  5,  for  removal of the outer race of bearing (9). NOTE Early  configurations  of  X200-4  utilize  2 retaining rings (11) with early configurations  of  Hydrostatic  Idler  Gear (10).  Later Configurations of X200-4 do not  utilize  retaining  rings  (11)  with  later configuration   of   Hydrostatic   Idler   Gear (10) 4 Using   screwdriver,   remove   two   retaining   rings (11)  when present. 5 Using   bearing   puller,   remove   inner   race   and rollers of bearings (7, 9) from idler gear (10). WARNING Hot  parts  can  burn  you.    Always  wear leather  gloves  when  working  with  parts that are or might be hot. 6 Using two heat guns, heat retaining plate (8) for one hour. 7 Using  arbor  press,  press  outer  race  of  bearing (7) from retaining plate (8). Go to Sheet 7 4-196  Change 2   Para.  4-29, Task 3