TM 9-2520-272-34&P
4-29.
REPAIR CENTER HOUSING COMPONENTS
(SHEET 7 OF 31)
Install Bearings
8
Using two heat guns, heat retaining plate (8) for
one hour.
9
Using arbor press, press new outer race of
bearing (7) to a seat in shoulder of retaining
plate (8).
10
Using arbor press, press against the numbered
end of bearing (7) to install inner race and rollers
of bearing (7) to a seat against the shoulder of
gear (10).
11
Using arbor press, press against the numbered
end of bearing (9) to install inner race and rollers
of bearing (9) to a seat against the shoulder of
gear (10).
NOTE
Retaining rings (11) have been removed
from later configurations. If removed it
is optional to replace them regardless if
early
configuration
Hydrostatic
Idler
Gear (10) is used.
12
Using screwdriver, install two retaining rings
(11).
13
Using arbor press, install bearing (5) to a seat
against shoulder on output shaft (6).
14
Using arbor press, install bearing (2) to a seat
against shoulder on left steer gear (4).
15
Using arbor press, install bearing (1) to a seat
against shoulder on left steer and output sun
gear (3).
FOLLOW-ON PROCEDURE: Install left steer and output
sun gear and bearing. Install left steer gear and
bearing. Install left output shaft and bearing.
Install idler gear and bearings. Refer to
paragraph 4-30.
End of Task 3
Go to Sheet 8
Para. 4-29, Task 3
Change 2 4-197
|
|
