TM 9-2520-272-34&P 4-30. ASSEMBLE  CENTER  HOUSING    (SHEET  15 OF 21) 1 Using rotary control on transmission maintenance   stand,   turn   transmission   to   input side up. WARNING Prior  to  placind  steer  control  assembly (1) on hydrostat (2), check to make sure control    rod    pin    (3)    is    engaged    into geedback lever (4).  If control rod pin (3) is  not  engaged  into  feedback  lever  (4), rotate    control    rod    (5)    until    engaged. Non-engagement will cause vehicle failure of full steer during start-up. 2 Place   steer   control   assembly   (1)   on   hydrostat (2). 3 Using  scoker,  install  two  5/16-18  x  2-1/4  inch bolts    (6)    and    washers    (7)    in    steer    control assembly (1). 4 Using   coker,   install   two   5/16-18   x   1-1/2   inch bolts    (8)    and    washers    (9)    in    steer    control assembly (1). 5 Apply   sealing   lube   on   threads   of   two   socker head screws (10). 6 Using  3/8  inch  socket  head  screw  attachment, install two socket head screws (10) in cam lever of steer control assembly (1). 7 Using   torque   wrench   and   socket,   tighten   four bolts (6,8) to 17-20 lb-ft (23-27)Nm). 8 Using   torque   wrench   and   socket   head   screw attachment, tighten two socket head screws (10) to 87-88 lb-ft (117-119Nm). End Of Task 5 Go to Sheet 16 4-226  Change 2 Para.  4-30, Task 5