TM 9-2520-272-34&P
4-30. ASSEMBLE CENTER HOUSING
(SHEET 6 OF 21)
18
19
20
21
22
23
24
25
26
27
28
Go
Install clutch disk (backing plate) (10) onto reaction
plate (7).
Using screwdriver, install retaining ring (11) to retain
backing plate (10).
Using screwdriver, install retaining ring (12) into range
pack bore.
Put front support assembly lifter tool J 24473 over
end of shouldered shaft (range input shaft) (13) and put
lower end of tool in groove below splined area of
center sun gear (14).
Using thumb S Crew on tool, tighten bottom of lifting
tool in groove.
Install S-hook in top of lifting tool.
Using hoist, S-hook and lifting tool, lower range input
shaft (13) and attached center carrier assembly (15) to
a seat against retaining ring (12).
Remove S-hook and lifting tool.
Using marker, mark edge of second clutch piston
housing assembly (16) above bolt hole.
lnstall second clutch piston housing assembly (16),
aligning bolt hole in piston housing assembly (16) with
Jolt hole in center housing.
Using 9/16 inch socket and extension, install washer
(17) and bolt (18) through center housing and into
piston housing assembly (16) finger tight.
to Sheet 7
Para. 4-30, Task 2
4-227
|
|
