4-5.   REMOVE   TRANSMISSION   TOP   COMPONENTS (SHEET  5  OF  8) 1   Using   socket,   remove   the   remaining   16   bolts   (1)   and washers   (2)   from   main   control   valve   assembly   (3). 2   Remove   main   control   valve   assembly   (3). NOTE No   solenoid   should   be   removed   from control   valve   assemblies   unless   procedures have   established   that   solenoid   malfunction exists. When   necessary   to   replace   a   solenoid,   or to   repair   solenoid   connector,   refer   to paragraph    4-31. FOLLOW-ON   PROCEDURE:   Install   main   control   valve   assembly.   Refer   to   paragraph   4-18. End  of  Task  3 TASK   4.   REMOVE   LOCKUP   CONTROL   VALVE   ASSEMBLY COMMON   TOOLS: Extension,   socket   wrench,   1/2   inch   square   drive,   6   inch Handle, Socket, socket   wrench,   1/2   inch   square   drive socket,   wrench,   1/2   inch   square   drive,   1/2   inch NOTE Transmission   top   cover   is   removed. Wiring   harness   does   not   have   to   be removed   to   remove   control valve    assemblies, Control   valve   assemblies   are   removed with   solenoids   attached. 1   Using   socket,   remove   six   bolts(1)   and   washers   (2). 2   Remove   lockup   control   valve   assembly   (3). NOTE No solenoid should be removed from control valve assemblies unless procedures            have established   that  solenod  malfunction  exists                   When  necessary  to  replace  a  solenoid,  or  to  repair  solenoid  connector,  refer  to paragraph  4-31. FOLLOW-ON   PROCEDURE:   Install   lockup   control   valve   assembly.   Refer   to   paragraph   4-18. End  of  Task  4 Go  to  Sheet  6 Para.  4-5,  Task  4 4-9 T M 9 - 2 5 2 0 - 2 7 2 - 3 4 & P