TM 9-2520-272-34&P
4-7. REMOVE RIGHT END COVER ASSEMBLY
(FEET 3 OF 7)
6 Using 9/16 inch socket, remove 27 remaining bolts (9)
and washers (10) from right end cover (1).
NOTE
Two legs of three-legged sling are used in
this task. When sling bolts are tightened,
they jack end cover from transmission
7 Install washers (11) on two 3/8-16 x 2 inch bolts (12)
and install bolts through sling lugs
8 Using 9/16 inch socket, install one bolt (12) in each
jack hole (13) on right end cover (1).
9 Alternately tighten two bolts (12) until end cover (1)
loosens
10 Using hammer, strike against elbow (14) to loosen end
cover (1).
11 Using hoist and sling, remove end cover (1).
NOTE
Outer steer shaft (refer to this paragraph
TASK 2) may be lifted out when end cover
(1) is removed.
12 Using 9/16 inch socket, remove two jack bolts (12),
washers (11) and sling from end cover (1).
13 Remove right end cover gasket (15).
REPAIR: Refer to paragraph 4-20 to repair right
end cover assembly.
FOLLOW-ON PROCEDURE: Install right end cover
assembly. Refer to paragraph 4-16.
End of Task 1
Go to Sheet 4
4-22
Para. 4-7, Task 1
|
|
