TM 9-2520-272-34&P
4-7. REMOVE RIGHT END COVER ASSEMBLY
(SHEET 4 OF 7)
OVERVIEW
The purposes of this task are to remove loose components that will drop out of the transmission
when the right side is lowered, and to remove tubes, including the tubes that must be removed
before the bevel gear assembly can be removed.
TASK 2. REMOVE RIGHT END TUBES AND LOOSE COMPONENTS
COMMON TOOLS:
Extension, socket wrench 1/2 inch square drive, 6 inch
Hammer, hand, machinist’s
Handle, socket wrench 1/2 inch square drive
Pliers retaining ring, external
Pliers, slip-joint
Puller, mechanical, gear and bearing, three-jaw
punch, center, tapered end
Socket, socket wrench 1/2 inch square drive, 9/16 inch
SUPPLIES:
Rag, wiping (Item 15, Appendix C)
Remove Outer Steer Shaft
• Wiggl
• R e t a i
NOTE
e shaft to remove, if necessary.
ning rings on steer shafts function as
stops They should not be removed unless
defective.
1 Remove outer steer shaft (1) from steer shaft drive
gear (2) in transmission (3).
2 Using retaining ring pliers, remove retaining rings (4)
from shaft (1) if out of round, bent, or if tension is lost.
TM85348
Go to Sheet 5
Para. 4-7, Task 2
4-23
|
|
