TM 9-2520-272-34&P
4-8. REMOVE LEFI END COVER ASSEMBLY (SHEET
5 OF 10)
1.
Using socket, remove two bolts (1) and washers
(2) from left lifting bracket (3). Remove bracket
from left end cover assembly (4).
2.
Using socket, remove the remaining 29 bolts (5)
and washers (6) from left end cover assembly
(4).
NOTE
Two legs of three-legged sling are used in this task.
When sling bolts are tightened, they jack end cover
from transmission.
3.
Install washers (7) on two 3/8-16 x 2 inch bolts
(8) and install bolts through sling lugs.
4.
Using socket, install two bolts (8) in jack holes
(9) on left end cover assembly (4).
5.
Alternately tighten two bolts (8) until end cover
(4) loosens.
6.
Using screwdriver, insert tip in crack between
end cover
(4)
and center housing (10). Pry cover loose.
7
hoist and sling, remove end cover (4).
8
socket, remove jack bolts (8), washers (7) and
sling from end cover (4).
9.
Remove left end cover gasket (11) and discard.
REPAIR: Refer to paragraph 4-23 to repair
left end cover assembly.
FOLLOW-ON PROCEDURE: Install left end cover
assembly. Refer to paragraph 4-15.
End of Task 3
Go to Sheet 6
Para. 4-8, Task 3
Change 2 4-29
|
|
