TM 9-2520-272-34&
4-8. REMOVE LEFT END COVER ASSEMBLY
(SHEET 7 OF 10)
Remove Range Input Gears, Hydrostatic Drive Gear,
Bevel Gear Driven Shaft and Filter Tubes
NOTE
Bearings are not to be replaced unless defective.
Refer to TM 9-214 for inspection of bearings.
1 Remove range input drive gear (1)
and hydrostatic
drive gear (2), together, from center housing (3).
NOTE
•
Range input drive gear and hydrostatic
drive gear should not be separated unless
one of these gears or inner race (4) must
be replaced.
•
When hydrostatic drive gear is removed,
inner race (4) is also removed.
•
Bearing outer race and rollers that match
race (4) remain in the center housing.
Refer to paragraph 4-29 to replace outer
race and rollers.
2.
Using bearing puller, remove race (4)
and hydrostatic drive gear (2) from range input
drive gear (1).
Go to Sheet 8
Para. 4-8, Task 4
Change 2 4-31
|
|
