ARMY   TM   9-2805-262-14 AIR  FORCE  TO  38G2-90-1 NAVY   NAVFAC   P-8-613-14E 4-27.   High   Tension   Cables. This  task  covers: a. Removal b.   lnspection/Test c. Installation INITIAL  SETUP T o o ls General  Mechanic’s  Tool  Kit  (Item  1,  Appendix  B) Multimeter (NSN 6625-01-139-2512) (Item 2, Appendix B) a. Removal. (figure 4-21) NOTE Tag  high  tension  cables  before  removing  from  engine. When  removing  high  tension  cables  on  engines  with  breakerless  ignition  system,  remove high  tension  cable  from  ignition  control  unit. (1) Loosen connector nut (1) and remove high tension cable (2) from spark plug (3). (2) Remove screw (4) and washer (5) and remove loop clamp (6) from high tension  cable (2) (3) Loosen connector nut (7) and remove high tension cable (2) from coil cover (8). (4) Repeat steps 1 through 3 as necessary for remaining high tension cables. b. Inspection/Test. (1) (2) (3) (4) 4-46 Inspect high tension cable (2) and replace cable if braided  shield is frayed, spring  end is distorted or damaged,  or  rubber  end  is  ripped  or  otherwise  damaged. Perform  continuity  test  between  spring  ends  of  high  tension  cable,  replace  cable  if  continuity  is  not present. Perform  continuity  test  between  metal  ends  of  high  tension  cable,  replace  if  continuity  is  not  present. Perform  continuity test between metal end and spring end of high  tension  cable,  and  replace  if  continuity is present.