TM  9-2815-202-34 4-24.   FLYWHEEL   HOUSING   REPLACEMENT This  task  covers: a.  Removal b. Cleaning/Inspection c.  -Installation INITIAL   SETUP MODELS EXPENDABLE/DURABLE   SUPPLIES All Engine oil (App C, Item 16) Grease (App C, Item 22) Cleaning solvent (App C, Item 10) Nonhardening sealant (App C, 39) TOOLS  AND  SPECIAL  TOOLS General Mechanics Tool Kit (App B, Item 96) Torque wrench (App B, Item 101) Guide studs (App B, Item 86) Multiple sling (App B, Item 83) MANDATORY  REPLACEMENT  PARTS 21  Lockwashers  (App  F,ltem  93) 8  Lockwashers  (App  F,ltem  95) 1  Gasket  (App  F,  Item  66) 2 Gasket (App F, Item 25) 2 Gasket (App F, Item 26) 1 Copper washer (App F, Item 163) EQUIPMENT   CONDITION Para  Description 4-2 Turbocharger  mounting  bracket  removed (7083-7395) 4-19 Blower drive removed 4-20 Oil pan removed 4-22 Flywheel removed 4-23 Rear oil seal removed 6-4 Exhaust manifold and tube removed (7083-7398) 6-16  Crankcase  breather  removed a.   Removal NOTE When  removing  flywheel  housing  bolts,  note  location  of  various  size  bolts  and  washers so  they  may  be  reinstalled  in  their  proper  location. (1) Install two eye bolts (1) to top of flywheel housing (2). Attach multiple sling (3) to eye bolts. NOTE Effective  after  engine  number  8VA-349268,  bolt  (4)  and  flat  washer  (5)  replaced  three bolts (6) and three flat washers (7) on left side of flywheel housing. (2) Remove bolt (4), flat washer (5), three bolts (6), three flat washers (7), six bolts (8), and six flat  washers  (9)  from  bell  of  flywheel  housing. 4-80 Change  1