(4)
(5)
(6)
(7)
(8)
(9)
TM9-2815-202-34
Position front cover (9) over two alinement pins and tap cover until it contacts cylinder block.
Install four bolts (4), two bolts (5), six Iockwashers (6), two bolts (7), and two Iockwashers (8)
to lower front cover (9).
Torque bolts (7) to 25-30 Ib-ft (34-41 N-m) and bolts (4 and 5) to 80-90 Ib-ft (108-122 N-m),
Install spacer ring (10) onto crankshaft.
Install end cap (3), flat washer (2), and bolt (1) to front of crankshaft.
Tighten crankshaft end bolt (1) as follows:
NOTE
Secure gear train in place to prevent crankshaft from turning when loosening
crankshaft end bolt.
(a)
(b)
(c)
(d)
Torque bolt to 180 Ib-ft (244 N-m).
Strike end of bolt a sharp blow three times with a 3 pound soft head hammer.
Torque bolt to 300 Ib-ft (407 N-m) and strike bolt again three times.
Torque bolt to 290-310 Ib-ft (393-421 N-m). Do not strike bolt after final torque has been
applied.
END OF TASK
FOLLOW-ON MAINTENANCE
Para Description
4-20 Install oil pan
4-5
Install fuel strainer
4-103
|
|
