TM9-2815-202-34 l NOTE m ModeIs 7083-7391, 7083-7396, and 7083-7399 require removal of five  bolk (4) and five Iockwashers  (5). . (b) Attach front end plate (3) to cylinder block with  bolt(1), Iockwasher (2), four bolts (4), and four Iockwashers  (5). Tighten bolts finger tight. (c) Wipe excess gasket cement from bores in end plate and cylinder block. NOTE Holes  in  end  plate  for  camshaft  end  bearings  are  not  same  size.  Smaller  hole  is accurately machined for alinement  purposes and is always located on right side of engine. (d) Insert right bank camshaft end bearing (17) through smaller bearing bore in end plate and into bore of block to accurately  aline  plate  with  block. (e) With end bearing in place, torque bolts (1) to 71-75 Ib-ft (96-102 N-m) and bolts (4) to 30-35 Ib-ft (41-47 N-m). (f) Remove camshaft end bearing (17) which served as a pilot while attaching end plate. Change  1 4-119